Store It Out MAX

BIVO-98 battery is only 38mm thickness and 668g light weight for handheld shooting. It's 98Wh capacity, run at least 1 hour on ARRI ALEXA 35 camera, and not being restricted to board airplane. The battery provides at least 150W constant power load for cine cameras and devices. › 14.4V/28.8V Bi-voltage B-mount › 98Wh fly-friendly capacity › 150W constant high load › D-tap 11-16.8V output ×2 › LED power & voltage indicators › Built-in LED torch › Strong 1.2m drop off proof › Multiple circuit protections 14.4V/28.8V Bi-Voltage B-mount Battery BIVO-98 is a 14.4V(11-16.8V) and 28.8V (22-33.6V) Bi-voltage B-mount battery, for ARRI cameras and various compatible with regular voltage cameras and cinegears. The battery will recognize the ID pin resistor value of the B-mount plate, and then output 14.4V or 28.8V, without any misuse risks. 98Wh Fly Friendly Capacity BIVO-98 battery is only 38mm thickness and 668g light weight for handheld shooting. It's 98Wh capacity, run at least 1 hour on ARRI ALEXA 35 camera, and not being restricted to board airplane. The battery provides at least 150W constant power load for cine cameras and devices. 2x D-tap Power Output BIVO-98 provides with 2x D-tap power sockets. When the battery works at 14.4V voltage, the D-tap outputs 11-16.8V; When the battery works at 28.8V voltage, the D-tap output regulated 16V, to power all kinds of camera-top devices. BIVO Series Family The BIVO series Bi-voltage B-mount battery famaily has 98Wh, 160Wh, 196Wh, 290Wh, the different sizes and capacities, for stablizer handheld light weight or long time power selection. LED Power/Voltage Indicators BIVO-98 has 4-level LED power indicators and an independent blue LED to indicate battery voltage. When the battery attached to B-mount plate, the blue LED turned on means the battery outputs 28.8V high voltage, and the blue LED off means the battery is 14.4V regular voltage. 33.6V Fast Charging You can charge 4x BIVO-98 simultaneously on SWIT PC-P461B B-mount charger, at 33.6V, 44W fast charging. The charger will take approx. 3 hours to fully charge 4x BIVO-98 batteries. LED Torch You can double press the Power Check button to switch on LED torch on the rear side of the battery, to help you to find B-mount plate in dark production environment. Double press the Power Check button again to switch the light off, and it will be automatically switched off after 30 seconds. Voltage 28.8V (21.6-33.6V) & 14.4V (10.8-16.8V) Capacity 98Wh Constant load (28.8V) 150W, 6A; (14.4V) 150W, 12A Charging 33.6V 44W fast charging Mount Type B-mount D-tap ×2 14.4V status: 10.8-16.8V out, 150W load 28.8V status: 16V regulated out, 50W load Charging Temperature 0-40°C Discharging Temperature -20°C-50°C (Capacity and Max Load may decrease when operating below 0°) Net weight Approx 668g Dimensions 144×100×38mm

ThinkVision T27QD-4V combines modern design, performance, and sustainability. The ThinkVision T27QD-4V is designed for professionals who expect more from their monitor. Its 27" QHD IPS panel delivers exceptional sharpness and natural color accuracy, making both work and communication pleasant and effortless. Video conferences run smoothly and professionally thanks to the integrated 5 MP camera, high-quality 5W speakers, and built-in microphone. AI-powered features such as automatic face framing, multi-person detection, and intelligent volume control adapt to your needs, ensuring every meeting flows seamlessly. Windows Hello support enables quick and secure logins with just a glance. The natural low blue light filter helps reduce eye strain and enhances comfort during long working hours. The USB-C docking feature simplifies your workspace — a single cable transfers video, data, and up to 100W of power to your connected device. ENERGY STAR and EPEAT Gold certifications highlight the monitor’s energy efficiency and environmentally conscious design, making it a smart choice for any modern workspace — in the office or at home. Top Features: Screen size: 27" Resolution: 2560x1440 QHD Panel type: IPS Aspect ratio: 16:9 Refresh rate: 48–120 Hz Brightness: 350 cd/m² Contrast ratio: 1500:1 Response time: 6 ms (Typical), 4 ms (Extreme) Color gamut: 99% sRGB, 99% BT.709 Color depth: 8-bit Ports: HDMI 2.1 TMDS, DP 1.4 (HBR2), DP-Out 1.4, USB-C 3.2 Gen1 (DP 1.4 Alt Mode), USB-C 3.2 Gen1 (15W PD, data only), 3x USB-A 3.2 Gen1, RJ45, audio combo USB-C power delivery: up to 100W (PD 3.0) Integrated webcam: 5.0 MP, IR + RGB Integrated speakers and microphone: Yes Power consumption (Typ/Max): 23.4W / 173W Viewing angle (H/V): 178° / 178° Tilt: -5° / 23.5° Swivel: -45° / 45° Height adjustment: 155 mm Pivot: -90° / 90° VESA mount: 100 x 100 mm Kensington lock slot: 2.5 x 6 mm Lenovo Display Fleet Manager (LDFM) and Lenovo Accessories and Display Manager (LADM) Included cables: USB-C (1.8 m) and DP (1.8 m) Weight: 7.2 kg with stand, 5.0 kg without stand Three-year replacement warranty Environmental Certifications ENERGY STAR Certified, TCO 10, TCO Edge 2.1, EPEAT™ Gold, EU Energy Efficiency Level (Level-F), Volatile Organic Compound Certification, RoHS Ergonomic Certifications Eyesafe® Display 2.0, TÜV Low Blue Light (Hardware Solution), TÜV Rheinland® Eye Comfort (5 Stars)

Features:  • Embedded processor • H.264+/H.264 dual-stream video compression • Support HDCVI/AHD/TVI/CVBS/IP video inputs • Max 8 channels IP camera inputs, each channel up to 5MP • Max 96Mbps Incoming Bandwidth • Smart Search and Intelligent Video System  Technical Specifications:  System • Main Processor Embedded Processor • Operating System Embedded LINUX Display • Interface 2 HDMI, 1 VGA, 1 TV • Resolution 1920×1080, 1280×1024, 1280×720, 1024×768 Multi-screen Display • 1/4/8/9/16/25 • OSD Camera title, Time, Video loss, Camera lock, Motion detection, Recording Video Detection and Alarm • Trigger Events Recording, PTZ, Tour, Alarm Out, Video Push, Email, FTP, Snapshot, Buzzer and Screen Tips • Video Detection Motion Detection, MD Zones: 396 (22 × 18), Video Loss,Tampering and Diagnosis • Alarm input 16 • Relay Output 6 • Tracking Trigger Event N/A Playback and Backup • Playback 1/4/9/16 • Search Mode Time /Date, Alarm, MD and Exact Search (accurate to second), Smart search • Playback Function: Play, Pause, Stop, Rewind, Fast play, Slow Play, Next File, Previous File, Next Camera, Previous Camera,Full Screen, Repeat, Shuffle, Backup Selection, Digital Zoom • Backup Mode USB Device/Network Storage • Internal HDD 8 SATA Ports, up to 8TB capacity for each disk • HDD Mode Single • eSATA 1 Port Auxiliary Interface • 4 USB Ports (2 USB 2.0 , 2 USB 3.0) • RS232 1 port, for PC communication & Keyboard • RS485 1 Port, for PTZ Control Third-party Support • Dahua, Arecont Vision, AXIS, Bosch, Brickcom, Canon, CP Plus, Dynacolor, Honeywell, Panasonic, Pelco, Samsung, Sanyo, Sony, Videotec, Vivotek, and more Audio and Video • HDCVI Camera Input 16 Channel • IP Camera Input 16+8 Channel, each channel up to 5MP • Audio In/Out 16 Audio In, 1 Audio Out • Two-way Talk 1 Mic In, 1 Mic Out, BNC Recording • Compression H.264+/H.264 • Resolution 1080P, 720P, 960H, D1, HD1, BCIF, CIF, QCIF Record Rate • Main stream: 1080P(1~15fps) 1080N/720P/960H/D1/HD1/BCIF/CIF/QCIF (1~25/30fps) • Sub steram:D1/CIF/QCIF(1~15fps) • Bit Rate 1Kbps ~ 6144Kbps Per Channel Record Mode • Manual, Schedule (Regular, Continuous), MD (Video detection: Motion Detection, Video Loss,Tampering), Alarm, Stop • Record Interval 1 ~ 60 min (default: 60 min), Pre-record: 1 ~ 30 sec, Post-record: 10 ~ 300 sec Network • Interface 8CH: 2 RJ-45 Port (1000M) Network Function • HTTP, TCP/IP, IPv4/IPv6, UPnP, RTSP, UDP, SMTP, NTP, DHCP, DNS, IP Filter, PPPoE,DDNS, FTP, Alarm Server, P2P, IP Search (Support Dahua IP camera,DVR, NVS, etc.) • Max. User Access 128 users • Smart Phone iPhone, iPad, Android • Interoperability ONVIF 2.4.1, CGI Conformant Electrical • Power Supply AC100V-240V, 50/60Hz • Power Consumption

SmallRig x Caleb Pike VB212 mini V Mount Battery 4293 adopts a highly integrated design, reducing the battery size and making it lighter and more portable. The battery combines fast-charging protocol chips, MCU, voltage control, and BMS chips. It supports a wide range of fast charging protocols (PD 3.1 / QC 3.0 / AFC, etc.), Two-way PD fast charging and discharging 140W (Max), and adaptive voltage / current regulation, etc.  In addition, its customized intelligent BMS system ensures faster and safer charging by providing overcurrent / short circuit / overtemperature / overvoltage protection, etc. The battery body is equipped with D-Tap / USB-C / USB-A / DC 8V-OUT / DC12V-OUT /  BP interfaces, which can charge or power camera / video camera / monitor / wireless image transmitter / LED video light / mobile phone / laptop etc., without using any V-mount plates. 1. Intelligent BMS chip supports 140W (Max.) fast charging, fully charged in 2.5 hours.2. Imported top-class large-capacity LG battery cell endures repeated charging and discharging, safe and stable.3. Highly integrated design, ultracompact and travel-friendly.4. Multiple interfaces: two USB-C ports, two D-Tap ports, one USB-A port, DC 8V-OUT, DC12V-OUT. Each interface adopts a parallel circuit to allow simultaneous USB-C and USB-A fast charging.5. Aluminum alloy, silicone, TPU, and PC V0 materials; four layers of aluminum frames on the inside with silicone coating on the outside, make the battery robust, drop-proof, heat-resistant, and flame-retardant.6. Durable, scratch-resistant PC and acrylic front cover.7. TFT display shows battery status clearly and accurately.8. The accurately designed cover and well-positioned grooves allow for easy and convenient operation. SmallRig x Caleb Pike VB212 mini V Mount Battery 4293 adopts a highly integrated design, reducing the battery size and making it lighter and more portable. The battery combines fast-charging protocol chips, MCU, voltage control, and BMS chips. It supports a wide range of fast charging protocols (PD 3.1 / QC 3.0 / AFC, etc.), Two-way PD fast charging and discharging 140W (Max), and adaptive voltage / current regulation, etc.  In addition, its customized intelligent BMS system ensures faster and safer charging by providing overcurrent / short circuit / overtemperature / overvoltage protection, etc. The battery body is equipped with D-Tap / USB-C / USB-A / DC 8V-OUT / DC12V-OUT /  BP interfaces, which can charge or power camera / video camera / monitor / wireless image transmitter / LED video light / mobile phone / laptop etc., without using any V-mount plates. The BMS chip has a built-in 16-bit Smart ADC, which, combined with the MCU and a TFT display, allows you to keep track of the battery status anytime, anywhere. Built-in premium battery cells (no inflated capacity) can be charged and discharged cyclically, ensuring excellent performance and stability. The design complies with internationally recognized standards such as MSDS / UN38.3 / IEC62133 / UL2054 / UL62368, making it safer to use. The aluminum alloy body with a silicone coating provides robustness and makes it drop-proof. TPU and PC V0 materials make the battery heat-resistant and fire-retardant. Scratch-resistant PC and acrylic cover add durability and protect the TFT display that shows battery status clearly and accurately. The accurately designed cover and well-positioned grooves allow for fast and easy interaction with the dust cover. Overall, this item is safe and powerful enough for you to capture every wonderful moment without any worries. Certification: FCC, CE, RoHS, ISED, PSE, RCM Button function:1. Click to check the battery level, and click again to turn off the screen.2. Double-click to switch the display port voltage and power.3. Click four times to turn on/off low current mode.4. Press and hold for 10 seconds to force restart.*Low current mode: In normal mode, low-power devices may not be able to be charged normally. In this case, the l

PV Combiner Box, DC 6in-6out, IP66   Features:  6 input 6 output 1000V DC. DC string box is designed for 6 string in - 6 string out PV system. For surge protection and isolating at solar DC side. Flame retardant rating V0, UV resistance, IP66 waterproof enclosure, lockable in closed position. With MC4 connectors. Box size 528 x 458 x 358 mm, standards IEC60529. DC switch:  1000V, 50A (3pcs.). Lockable handle. Patented DC arc extinguishing chamber. Standards: UL508i, IEC60947-3 Pv2. DC surge protection device SPD:  1000V, 40kA. (6pcs.). Designed for solar PV protection. Response time